Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: New Domino started cutting smaller width holes (5mm cutter)  (Read 882 times)

0 Members and 1 Guest are viewing this topic.

Offline lehrfeld

  • Posts: 1
New Domino started cutting smaller width holes (5mm cutter)
« on: November 14, 2018, 08:50 PM »
Hi All - I just started my Festool journey thanks to the $100 back tool trade-in... little did I know that was just a taste of the crack... a TS55, MFT/3 and a Domino later here I am.

My 3 week old Domino just started cutting undersized holes.  I was cutting along on a cabinet build and everything was good, then all of a sudden, the holes were a little undersized.  I can't fit the dominos into the holes anymore.  I took the cutter off and reseated it, made sure that all the setting were correct and still nothing. I have used a total of less than 100 dominoes! 

Anyone have a tip/trick that a newbie might be missing?  I was using it with the Domiplate if that matters at all.

Thanks in advance!  Mike

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline JD2720

  • Posts: 1029
Re: New Domino started cutting smaller width holes (5mm cutter)
« Reply #1 on: November 14, 2018, 09:10 PM »
Welcome.
Check the bit. I am guessing that the end broke off of it.
You would not be the first it has happened to.

Offline Birdhunter

  • Posts: 2382
  • Woodworker, Sportsman, Retired
Re: New Domino started cutting smaller width holes (5mm cutter)
« Reply #2 on: November 16, 2018, 05:47 AM »
My guess is that JD is correct. If the tip is still attached to the 5mm cutter, try another sized cutter.
Birdhunter

Offline rst

  • Posts: 2037
Re: New Domino started cutting smaller width holes (5mm cutter)
« Reply #3 on: November 17, 2018, 09:19 AM »
I had the same problem the last time I used my 8mm cutter  Being in a hurry it took sanding two dominoes down to fit to realize that something was wrong.  I looked at the cutter and it looked fine.  That stumped be until I realized that I hadn't used it for a month or more.  That last time I had nicked a 23 ga pin in the material I was using.  I had examined the cutter then and it looked fine, I reexamined the cutter with my magnifying goggles and saw tiny chips were off the outer edges...time to change cutters.  Also bought extra CMT replacement bits.