Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: PDC4 Drill  (Read 1508 times)

0 Members and 1 Guest are viewing this topic.

Offline dingo

  • Posts: 2
PDC4 Drill
« on: March 26, 2018, 05:49 AM »
Just purchased the 18v PDC4 and noticed that the metal ring on the end of the 13mm chuck keeps spinning after chuck stops. Its bloody annoying haha. Has anyone else had this issue? Cheers

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mrB

  • Posts: 445
Re: PDC4 Drill
« Reply #1 on: March 26, 2018, 09:25 AM »
Not sure it's an 'issue'.  It's designed to prevent the chuck damaging any surface it comes into contact with. Like when drilling deep into a corner.
there's nothing like the right tool for the job

Offline serge0n

  • Posts: 49
Re: PDC4 Drill
« Reply #2 on: March 26, 2018, 03:30 PM »
It definitely is a feature. Apart from damage prevention, the ring also allows for fine control when precise drilling is required -- you can hold the chuck part of the drill by hand and guide it with much higher degree of precision. 

Offline dingo

  • Posts: 2
Re: PDC4 Drill
« Reply #3 on: March 27, 2018, 04:24 AM »
Thanks guys, that makes sense.