Author Topic: OF1400 Offset  (Read 3129 times)

0 Members and 1 Guest are viewing this topic.

Offline birchwoodwerks

  • Posts: 74
OF1400 Offset
« on: July 12, 2015, 01:13 PM »
Ive been looking on the site and cant find the answer. Ive measured and it looks to be about 57mm. But what is the exact measurement from the side of the OF1400 to the "center of bit". Thanks in advance
TS75,FS1080/2,FS1900/2,FS2424/2 LR32,CT36,
RO125,ETS125,DF500,Domino,RS2,TI-15 set,850HL,Installer set, systainer,OF1400,Carvex 420 D handle,new CXS set, compact cleaning set,  12 drawer Sortainer.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 11291
  • Another Avatar Coming Soon
Re: OF1400 Offset
« Reply #1 on: July 12, 2015, 02:18 PM »
You can measure it.  Place a ruler along the flat side and then there is a mark on all four sides on the side of the base which is the centerline.

Peter

Offline birchwoodwerks

  • Posts: 74
Re: OF1400 Offset
« Reply #2 on: July 12, 2015, 02:21 PM »
I did it says 57mm but it was a little off I wasn't sure if there was a more accurate number from festool. Thanks for the help
TS75,FS1080/2,FS1900/2,FS2424/2 LR32,CT36,
RO125,ETS125,DF500,Domino,RS2,TI-15 set,850HL,Installer set, systainer,OF1400,Carvex 420 D handle,new CXS set, compact cleaning set,  12 drawer Sortainer.

Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 11291
  • Another Avatar Coming Soon
Re: OF1400 Offset
« Reply #3 on: July 12, 2015, 06:53 PM »
Sorry.  I know that some people don't know about the centerline marks on the router bases and thought that you might have been measuring to the center of the collet.

Peter

Offline birchwoodwerks

  • Posts: 74
Re: OF1400 Offset
« Reply #4 on: July 14, 2015, 05:36 PM »
No worries I appreciate the response
TS75,FS1080/2,FS1900/2,FS2424/2 LR32,CT36,
RO125,ETS125,DF500,Domino,RS2,TI-15 set,850HL,Installer set, systainer,OF1400,Carvex 420 D handle,new CXS set, compact cleaning set,  12 drawer Sortainer.