Author Topic: Video Review of Festool MFT System (495462 & 495565 & 495888)  (Read 65567 times)

0 Members and 1 Guest are viewing this topic.

Offline Sparktrician

  • Posts: 3664
Re: Video Review of Festool MFT System (495462 & 495565 & 495888)
« Reply #60 on: November 09, 2018, 10:34 AM »
@GarryMartin, I've abandoned that method pretty much entirely since I came up with a better methodology a couple of years ago.  It worked, but it was clunky and needed a few custom-made pieces. 

I've since migrated to a sequential system starting with a set of QWAS dogs.  You might want to read this thread.  Feel free to ping me if you have any questions.   [smile]
- Willy -

 "Remember, a chip on the shoulder is a sure sign of wood higher up." - Brigham Young

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline GarryMartin

  • Posts: 1697
Re: Video Review of Festool MFT System (495462 & 495565 & 495888)
« Reply #61 on: November 09, 2018, 11:00 AM »
I've since migrated to a sequential system starting with a set of QWAS dogs.  You might want to read this thread.  Feel free to ping me if you have any questions.   [smile]

It wasn't for me; I was just trying to help someone else out, but thanks regardless.

@thedevme you may want to check out @Sparktrician link.

Offline thedevme

  • Posts: 3
Re: Video Review of Festool MFT System (495462 & 495565 & 495888)
« Reply #62 on: November 10, 2018, 01:03 PM »
(Attachment Link)

(Attachment Link)

(Attachment Link)

Garry You are my idol thank you so much I just got everything in today and these pictures are perfect I am going to make a doc.

Offline thedevme

  • Posts: 3
Re: Video Review of Festool MFT System (495462 & 495565 & 495888)
« Reply #63 on: November 10, 2018, 01:08 PM »
@GarryMartin, I've abandoned that method pretty much entirely since I came up with a better methodology a couple of years ago.  It worked, but it was clunky and needed a few custom-made pieces. 

I've since migrated to a sequential system starting with a set of QWAS dogs.  You might want to read this thread.  Feel free to ping me if you have any questions.   [smile]

Thanks I will try it out as well