Author Topic: Adapting a Triton dust collector to the CTL 26  (Read 379 times)

0 Members and 1 Guest are viewing this topic.

Offline digilante

  • Posts: 6
Adapting a Triton dust collector to the CTL 26
« on: August 29, 2018, 01:41 PM »
Hi all,

I have a Triton dust collection bucket as per attached pic. The inner diameter of those holes is 28mm, and the outer diameter just under 32mm (the Triton hoses are 32mm inner diameter, so they fit over the outer side of the holes / connectors).

The CTL 26 E comes with a D 27/32 hose.

Any ideas on where to get (preferably in Europe) the correct adapter to make the two fit?

Also, I read that the D 27/32 has a "Conical geometry (27 mm to 32 mm) for improved suction power". I've measured every part of this D 27/32 hose inside, out, and sideways and nothing seems to be close to 27 or 32 anywhere. Which part exactly are these measurements referring to?

Sorry - new to Festool dust extration.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.