Author Topic: Building a 10mm shelve with domino DF 500  (Read 376 times)

0 Members and 1 Guest are viewing this topic.

Offline bulubuluplopplop

  • Posts: 18
Building a 10mm shelve with domino DF 500
« on: March 03, 2018, 11:12 AM »
Hello,

I want to build a shelve with 10mm plywood stock and 4x20 domino.

How do I set up the domino DF500 with 10mm thickness, the "classical" method from the user manual will not work with 10mm thickness.
I don't care if the domino is not exactly centered in the plywood thickness.



this is my shelve plan:



Thank you !


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline bulubuluplopplop

  • Posts: 18
Re: Building a 10mm shelve with domino DF 500
« Reply #1 on: March 03, 2018, 01:41 PM »
ok, this is what I came up with. Not sure if it's the easiest way...

On scrap pieces of the same size as my shelve, to assemble this T like that:







First, to center the mortise in my 10mm stock, I add a 5mm shim beneath the part. With the 10mm from the table to the bit center, the mortise is centered in the plywood.
I add a 16mm setup block on the side against the guide stop dog to be able to make 2 mortises in the part:




Which gives me this:



And I repeat the same on the second part:
(veritas 4 + 1 = 5mm shims)






Result is not bad:


« Last Edit: March 03, 2018, 01:44 PM by bulubuluplopplop »