Author Topic: Guide Rail handles  (Read 932 times)

0 Members and 1 Guest are viewing this topic.

Offline ihadmail

  • Posts: 9
Guide Rail handles
« on: November 06, 2018, 11:01 PM »
I have one of the FS 3000 guide rails and use the Woodpecker Paralel Guides with it. I would like to have some kind of handles for the setup to make it easier to move from sheet to sheet.

I’ve searched around and haven’t found anything that matches what I’m looking for.

I’m thinking something that could attach to the t-slot would be best so that it’s easily removable for storage. Either a vertical piece, like a parf super dog, or a curved piece with two attachment points, like a grripper handle, would work. I’ve included a couple of rudimentary images in case my description is unclear.

Could any of you suggest a product that I could use to make lifting the rail/guides easier and more manageable?


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline lwoirhaye

  • Posts: 234
Re: Guide Rail handles
« Reply #1 on: November 07, 2018, 01:29 PM »
I don't know of any product but making a handle would not be difficult.  Find a nut that fits in the slot, grind it down if you have to.  Plastic handles with a threaded rod embedded are available in different thread sizes.  Lee Valley and  other suppliers sell these sorts of handles.

Offline tomp

  • Posts: 48
Re: Guide Rail handles
« Reply #2 on: November 07, 2018, 04:59 PM »
Here is a handle that I made, using the connector from a Rip Dog parallel guide, a block of UHMW and a knob.  It works very well, particularly with the TSO square as it allows you to apply a force in line with the track to keep the square tight to the edge of the sheet being cut.  It's been a PITA though to disassemble when I need the connector for the parallel guide so I'm thinking that I can make the same thing with a piece of aluminum, connectors and a knob when I can get some free time.

287373-0287375-1287377-2

Offline ihadmail

  • Posts: 9
Re: Guide Rail handles
« Reply #3 on: November 07, 2018, 08:45 PM »
Thanks for the replies and the photos! I think I'll try out some of Rockler's long handles and a couple of t bolts.

I'll post photos and how it worked out after I get everything in.