Author Topic: LR32 Linear Stop pin size  (Read 452 times)

0 Members and 1 Guest are viewing this topic.

Offline IOTrav

  • Posts: 2
LR32 Linear Stop pin size
« on: March 20, 2017, 05:34 PM »
Hey everyone.  First post here but have been reading for years.

I have an LR32 and am going to get a custom set of Qwas dogs to assist in using it to drill out a custom oversized MFT.  I want to use the linear stops on the LR32 to register in the previous row of drilled holes.  I contacted Steve over at Qwas and he said he would punch a hole in the center of a pair of Qwas dogs for me.  My cheap digital calipers say the pins on the LR32 Linear stops are about 6 mm.  Can anyone confirm that?  What is the actual size of those pins?  If I were going to register those in a hole what size should it be drilled?

Thanks Everyone

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.