Author Topic: MFS question  (Read 2038 times)

0 Members and 1 Guest are viewing this topic.

Offline Tinker

  • Posts: 3711
MFS question
« on: March 30, 2007, 06:45 AM »
I buy most of my lumber rough cut.  The dimensions are sometimes way out of consistant and before running thru surface planer, i must true up one face.  One of the methods i use is to clamp the piece to my MFT with the MFT-SP clamps at each end, truest face down.  I clamp a couple of 2x3's or 2x4's at each side of the piece i am working on. Clamp a piece of slotted ply wood across the 2x's and run my router back and forth within the limits of the slot.  When the area is cleaned up ( afew ridges here & there easilly cleaned up with a block plane)  i move the plywood to next section and so on.  In looking at the MFS with the guide plate, is it possible or sensible to use that in the same way.  With my method, I go by eys at ends of the plywood slot and eventually, the edges of the 2x gets quite chewed up.  The guide bushing prevents the plywood from getting damaged and it can be used many times. 

Is there a limiting clamp to be inserted each end of the slide plate so i would not tear into the MFS rails?  Has anybody else tried this method.  I find that if there is a lot of discrepancy to thickness dimensions, this it the quickest way for me to true up one face acurately.
Tinker
Wayne H. Tinker

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Ned

  • Posts: 1147
Re: MFS question
« Reply #1 on: March 31, 2007, 05:24 PM »
Michael,

Quote
The ring protrudes below the slide; at the end of the slot, the ring will hit the extrusion, protecting it from the bit.

Ned

Nested self-quotes.  Neat.

Ned