Author Topic: 1/2" stock DT Template for VS600  (Read 1811 times)

0 Members and 1 Guest are viewing this topic.

Offline cdconey

  • Posts: 96
1/2" stock DT Template for VS600
« on: August 14, 2007, 08:40 AM »
Would like to see a template for 1/2" stock for dovetails. Been using 12mm stock alot for drawers and doweling them, but have to use another brand to do half blind dovetails in my drawer stock.

The dangers of cut & paste.....

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Timmy C

  • Posts: 462
Re: 1/2" stock DT Template for VS600
« Reply #1 on: August 17, 2007, 09:11 PM »
I am with you on that one.  Here in the US, we have gotten so used to the 150 to 200 buck jigs, that work well for quick and efficient fabrication of 1/2" stock, it would sure be nice to have the ability to do that deal with simply changing a template.  I suppose however, for a PC Jig that is under 175, it is hard not to just dedicate it to 1/2" and dedicate a little PC690 as well.