Author Topic: MFT/3 Guide Rail Support System  (Read 3047 times)

0 Members and 1 Guest are viewing this topic.

Offline monkeysimple

  • Posts: 9
MFT/3 Guide Rail Support System
« on: February 15, 2017, 07:34 AM »
I am new to the MFT/3 world.  I would like to be able to cross cut full width 4x8 sheets.  Has anyone seen a way to add on an expansion (maybe with 80/20) to use the existing guide rail supports with pivot and switch out to a 1400?  Thanks.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline DrD

  • Posts: 409
  • I might not be fast BUT I sure am slow
Re: MFT/3 Guide Rail Support System
« Reply #1 on: February 15, 2017, 09:07 AM »
I took 2 MFT/3s and joined them long side to long side using Bosch Rexroth profiles, and spanned them with a FS1900 rail, allowing me more than enough room to cross cut a full sheet of ply.  By raising the rail and dropping the non-pivot side rail support down to just below table height, and placing some shop-made support tables at the rear, I can rip the full sheet as well by connecting 2 FS1400 rails utilizing a Betterley alignment aid.

Hope this helps.

KS12 EB Kapex with Delta Folding Table & FastCap Best Fence; TS75 EQ with Parallel Guide Rail Set (FS-PA 495717 & FS-PA-VL 495718) and FS 800/2, 1080/2, 1400/2 LR32, 1400/2, 1900/2 Guide Rails, and Betterly SLC23 Straight Line Connector; DF500 Q with Assortment Systainer; OF1010 EQ with Fine Adjuster for Guide Stop, WA-OF Angle Arm, UP-OF Edging Plate and SF-OF Chip Deflector (486242); OF1400 EQ with OF1400 Dust Hood x 2, OF 1400  Edge Guide x 2, OF 1400  Guide Stop; LR32 Set; PSB399 EQ; EHL65 E; RAS115.04 E; RS2 E; ETS150/3 EQ; RO150 FEQ; Hand Sanding Block Set; CT26 with assortment of AS and Non-AS Hoses; MFT/3 Table x2; SysLite; Assortment of Quick & Screw Clamps, Consumables, Dogs.