Author Topic: Suggestion for Kapex improvement  (Read 1913 times)

0 Members and 1 Guest are viewing this topic.

Offline Steve Rowe

  • Posts: 828
  • Teach them safety when they are young.
Suggestion for Kapex improvement
« on: December 22, 2014, 06:37 PM »
After doing crown in several rooms with the Kapex, the angle finder and lasers work great together.  What is missing is a micro-adjust on the miter angle to achieve optimum results.  The bevel adjustment has one, why not for the miter.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Johnny5

  • Posts: 30
Re: Suggestion for Kapex improvement
« Reply #1 on: December 22, 2014, 07:20 PM »
They could punch out the holes in the sticker over the laser adjustment..... [scratch chin]

Offline Harvey

  • Posts: 135
Re: Suggestion for Kapex improvement
« Reply #2 on: December 22, 2014, 10:11 PM »

Can't disagree. But perhaps this thread may help-
Kapex miter solution
Just a duffer

Offline Knight Woodworks

  • Posts: 218
Re: Suggestion for Kapex improvement
« Reply #3 on: December 26, 2014, 01:37 PM »
Steve

I agree, a micro adjust for the miter would be great. In the mean time I keep a few small pieces of paper, business card and some thin P-lam near the saw which I use to shim the work at the fence. 

John