Author Topic: Emtech 9300 + CL100 crosslinker  (Read 1099 times)

0 Members and 1 Guest are viewing this topic.

Offline bnaboatbuilder

  • Posts: 130
Emtech 9300 + CL100 crosslinker
« on: February 16, 2018, 12:13 PM »
I'll be spraying 8 walnut table tops for a restaurant within the week. Using a Fuji T75G gun/PPS cup, Target Coatings Emtech 9300 and the CL100 crosslinker. The coating appears to be a very good choice for high use/heavy cleaning table surfaces in more commercial settings.

Application looks to be straightforward. I'll update with my experience later on.

Curious if anyone has used this combo before? Were you pleased with the final results?
- John

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Trevin

  • Posts: 83
Re: Emtech 9300 + CL100 crosslinker
« Reply #1 on: February 16, 2018, 03:54 PM »
I have not but am interested in your results.  Please post with your thoughts on that combination as well...

Festool: MFT3 (x2), OF1010, OF1400, LR32, Domino DF500, Domino XL DF700, Kapex KS120, TS-75, Carvex 420, CXS, C-18, Vecturo OS 400, DTS 400, Pro 5, Rotex 125, VAC-PMP, VAC-SYS-1, VAC-SYS-2, CT-26 (x2), CT-SYS, SYS Light DUO, SYS-ROCK
Other: Minmax FS41, Sawstop PCS (3HP, 52"), Laguna BX14, Jet 17" Drill Press, Rikon 70-220VSR Lathe, Incra LS Router Station, Laguna P/Flux 3 Dust Collector

Offline kcufstoidi

  • Posts: 768
Re: Emtech 9300 + CL100 crosslinker
« Reply #2 on: February 17, 2018, 07:53 AM »
The EM9300 sprays nice for me when thinned with least at 5% with water. Be careful with the crosslinker and make sure its fresh. Its given me a finish that was like sandpaper. The finish typically gives walnut a lifeless look when used on its own because it clear. You may want to do a few test pieces to make sure its what you are looking for, some like this look. it will be interesting to see how it holds up to restaurant abuse especially on a soft hardwood like Walnut.