Author Topic: Failing Oil on Cedar Shingles  (Read 975 times)

0 Members and 1 Guest are viewing this topic.

Offline nkpaintingvt

  • Posts: 23
Failing Oil on Cedar Shingles
« on: May 21, 2017, 10:16 AM »
Hello,

Not quite sure how to approach prep on this project. Product was a semi-transparent oil stain from Cabot, applied by the carpenters by dipping when it was installed 10 years ago. It's failing via peeling and flaking and it doesn't look like it ever absorbed well into the substrate.

It comes off pretty easily with a gentle pass with a scraper, so it wouldn't be difficult to remove. Just wondering what's the best way to proceed. Clients want a similar color and look, just one that'll hold. Light pressure wash with a stripper/brightener combo? Strip it with one of my Festools?

Thanks for looking!

Noah
RO 125, RO 90, ETS 125, ETS 150/5, RTS 400, LS 130, RAS 115, CT MIDI

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline antss

  • Posts: 1432
Re: Failing Oil on Cedar Shingles
« Reply #1 on: May 22, 2017, 12:34 PM »
I think 10 years is pretty good for an exterior stain exposed to the sun/weather.

I'd scrape or wire brush the loose stuff off and re-coat it.  Pressure washer will eat up cedar.