Author Topic: Finishing advice for window sills  (Read 1012 times)

0 Members and 1 Guest are viewing this topic.

Offline Pnw painter

  • Posts: 107
Finishing advice for window sills
« on: October 15, 2017, 11:22 AM »
I'm finishing some Beech window sills and I'm attempting to match the built-in cabinets done by a local prefinisher. The prefinisher gave me a gallon of the stain they used for the cabinets, but that's all the info I have at the moment.

At this point I'm trying to figure out what products and process I should use for these sills? I'm guessing they used lacquer for the cabinets, so I was thinking about using SW high-Bild Precat Lacquer, but I'm not sure what sanding sealer to use if I use this product.

Any advice, guidance, etc... would be helpful. Basically, what would you do if you were in my shoes?


Sent from my iPad using Tapatalk

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline TSO Products

  • Retailer
  • *
  • Posts: 499
    • TSO Products
Re: Finishing advice for window sills
« Reply #1 on: October 15, 2017, 02:54 PM »
I'm not a professional painter but I have learned to do a test/trial on other than the "live" workpiece on any task/procedure/process that I have not done before.
-saves a lot of stress and that hateful "rework" [smile]

Hans
TSOproducts.com

Home of the GRS-16 and GRS-16 PE Guide Rail Squares -  the MTR-18 Triangle and Work Holding solutions