Author Topic: Fuji Pressure Pot  (Read 2268 times)

0 Members and 1 Guest are viewing this topic.

Offline JCLP

  • Posts: 856
Re: Fuji Pressure Pot
« Reply #30 on: June 12, 2018, 04:02 PM »
Hi
Looking for an air  psi setting to start with for  the fuji 2.5 gallon pot and a T70 gun
It all depends on the viscosity of the paint and how long the fluid tube is. When you pressurize the tank you will see the pain go up the tube about 1/2 way. When you depress the trigger on the gun, you will then see the paint flow faster. Try setting the pressure at 10psi and see how much paint is delivered. When you are able to atomize the paint and get good coverage, then you found it. If too much decrease pressure, if not enough, increase pressure. I found somewhere between 10-14psi works for me, but again its dependant on the viscosity of the material.

Cheers,
JC

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Online Twoodman66

  • Posts: 93
Re: Fuji Pressure Pot
« Reply #31 on: June 12, 2018, 04:14 PM »
Ok thank you. Going to start with Kem Aqua

Offline brewster201

  • Posts: 64
Re: Fuji Pressure Pot
« Reply #32 on: June 12, 2018, 04:49 PM »
10-13 psi depending on material viscosity

Bruce
Hand Woodworking