Right now I'm using a cheap Harbor Freight setup with a pressure pot, and the pot definitely has its worth in regards to gun mobility. However, it's a cheap Harbor Freight setup, and difficult to dial in the air/paint/fan settings, as well as causes a lot of overspray and bounceback.
I also have a Rockler HVLP setup, but I could not get it to spray SW ProClassic without blobbing, wouldn't atomize (even with 10% thin + floetrol).
So again I'm spraying SW PC, and need to consider a high end finishing setup because 1, I'm over experiencing the frustration and clunkiness of these low end systems, and 2, #1x1000 + I need to produce a high end product for the client.
I understand that folks seem to like the 3M PPS setup, but I haven't done enough research on what that means, will do that now.
Basically if you were me, with the need to spray SW PC into boxes, needing a high end finish, and actually have a bottom to your pockets, which direction would you go?
Thanks @ Paul G I'll look into the Apollo setup too...