Author Topic: Question about GF Arm-r-seal  (Read 991 times)

0 Members and 1 Guest are viewing this topic.

Offline bkharman

  • Posts: 1983
Question about GF Arm-r-seal
« on: January 20, 2018, 01:25 PM »
Hey all,

Normally when I use arm-r-seal, I have the luxury or time to wait for adequate dry/cure times. I don’t have that on a pantry project at the moment. Bear with me here...

I have had three coats on the top of this countertop but completely forgot that I didn’t put a single on on the stained bottom side! (Insert funny jokes here)



I coated the bottom with a single coat this morning and it is dry to the touch. Question is, how long should I wait to install it. It is just the bottom and won’t be touched in the dadoes and rabbets but didn’t want to both anything up. My gut says wait until tomorrow morning, but I need to get rolling on the next steps and prefer to get it into place sooner. All thoughts are welcome!  Here is the underside right after I put the coat on.



Cheers. Bryan.


Sent from my iPhone using Tapatalk
People, I just want to say, you know, can we all get along? Can we get along?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tjbnwi

  • Posts: 5619
  • Cedar Tucky Indiana
Re: Question about GF Arm-r-seal
« Reply #1 on: January 20, 2018, 01:29 PM »
Carefully install it.

Leave the door open so the pantry can air out.

Tom

Offline bkharman

  • Posts: 1983
Re: Question about GF Arm-r-seal
« Reply #2 on: January 20, 2018, 02:06 PM »
Thanks Tom. It is open shelves and baskets, so it should be fine.

Hope all is well with you these days!

Cheers. Bryan.


Sent from my iPhone using Tapatalk
People, I just want to say, you know, can we all get along? Can we get along?

Offline tjbnwi

  • Posts: 5619
  • Cedar Tucky Indiana
Re: Question about GF Arm-r-seal
« Reply #3 on: January 20, 2018, 02:31 PM »
Thanks Tom. It is open shelves and baskets, so it should be fine.

Hope all is well with you these days!

Cheers. Bryan.


Sent from my iPhone using Tapatalk

All is good. Making a few changes.....more to come.

Hope all is well with you too.

Tom

Offline bkharman

  • Posts: 1983
Re: Question about GF Arm-r-seal
« Reply #4 on: January 20, 2018, 08:54 PM »
So I got it installed. Fit like a glove!

Onto the trim and shelves. I will document the whole thing a bit later, but this is coming along nicely so far.

Cheers. Bryan.









Sent from my iPhone using Tapatalk
People, I just want to say, you know, can we all get along? Can we get along?