Author Topic: Refinishing Solid Surface  (Read 1244 times)

0 Members and 1 Guest are viewing this topic.

Offline joesan

  • Posts: 21
Refinishing Solid Surface
« on: December 28, 2016, 08:09 PM »

I have a solid surface bath tub that's got a little scuffed and has yellowed with age. I'd like to refinish it to get it back to a nice fresh matt white.

Can anyone advise me how best to refinish it? I only have a Rotex 125 sander. Since I really only want to remove the yellowing and go to a  matt level of finish, will I be able to get away with only one grit level?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline antss

  • Posts: 1452
Re: Refinishing Solid Surface
« Reply #1 on: December 28, 2016, 08:44 PM »
Flexible backer and  a  series of Vlies ought to do it.


Offline tjbnwi

  • Posts: 5310
  • Cedar Tucky Indiana
Re: Refinishing Solid Surface
« Reply #2 on: December 29, 2016, 04:04 PM »
Are you certian the tub is solid surface? I find that unusual. Here gel coated fiberglass or light acrylic are common.


Interface pads, 320 or 400 grit Granat. Set the Rotex in the random mode, not the Rotex mode.

http://rotex.festoolusa.com/sanders/models/Accessories/

Tom

Offline joesan

  • Posts: 21
Re: Refinishing Solid Surface
« Reply #3 on: December 29, 2016, 07:19 PM »

Thanks folks. I appreciate the advice.

Yes, the bath is a type of solid surface called Cristalplant. It's pretty much identical to Corian, but cast. Finishing techniques should be the same.

I'll try your suggestions. Any tips on how fast to move along the surface?