Author Topic: Tiny bubbles in EM6000 Laquer using HVLP gun  (Read 1167 times)

0 Members and 1 Guest are viewing this topic.

Offline jaguar36

  • Posts: 184
    • Toolamanjaro.com
Tiny bubbles in EM6000 Laquer using HVLP gun
« on: September 07, 2017, 11:31 AM »
I've been having some difficulties spraying Target EM6000.   When I tried to spray it I am getting lots of tiny little bubbles in the finish.  Tried to take some pictures but wasn't able to really get anything meaningful.

For reference I'm spraying a 3-mil thick coat, with a CA Technologies CAT-X HVLP spray gun with a 1.3mm tip running at about 25psi.  Its fed with cool, dry air, and the spray booth is at 71 degrees, 69.5% relative humidity.

Anyone happen to have any ideas what might be causing this?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tjbnwi

  • Posts: 5310
  • Cedar Tucky Indiana
Re: Tiny bubbles in EM6000 Laquer using HVLP gun
« Reply #1 on: September 07, 2017, 04:56 PM »
Could not resist;



The issue is called micro foaming. Can be to much air, to close to item being sprayed, larger panels wet over product that is starting to dry.

Tom

Offline jaguar36

  • Posts: 184
    • Toolamanjaro.com
Re: Tiny bubbles in EM6000 Laquer using HVLP gun
« Reply #2 on: September 20, 2017, 07:49 AM »
I spoke with Jeff over at Target Coatings and it turned out the issue was  air entrapment in the fluid handling cup.  I was using a PPS pressure cup and switched over to a gravity fed and the issue went away!

I'm shocked that with how finely the finish gets atomized out of the gun that any air in the cup would matter, but it does seem that was the issue.

Still wasn't ever able to get the CL100 to mix in without getting solids forming in the finish though.