Built a toddler bed for my two year old. One sheet of 3/4" Sapele ply and some re-purposed mahogany from an old bookcase.
Used the of1010 to make the half circle jigs. The carvex to cut the ply close. The cms vl and of 1400 with a large copy bit to get the plywood shapes to the pattern. Kapex to cut the miters on the corners. Dominos in each corner. Cms with a straight bit to joint one edge of a mahogany board, which i then ripped to 2 mm for the edge banding. Lather, rinse, repeat. The jointed edge was glued down to the plywood, and the saw cut edge sanded later on finishing. Sanded with the ro 150 and the rts 400. Two coats of surfix heavy duty oil with the vlies in between.
All done before, at lunch, and after work, on site.