Author Topic: Completely handmade plane.  (Read 3416 times)

0 Members and 1 Guest are viewing this topic.

Offline backwoodsbeagle

  • Posts: 12
Completely handmade plane.
« on: March 15, 2013, 10:28 AM »
Hello, here is a smallish plane that I completed a few weeks ago. I though maybe it would interest some of you hand tool guys.  The iron is forged from an old planer blade. The body was shaped by hand from two 1x4 scrap pieces of oak and maple glued together.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Chris Wong

  • Festool Dealer
  • *
  • Posts: 866
  • I make sculptural furniture.
    • Flair Woodworks
Re: Completely handmade plane.
« Reply #1 on: March 15, 2013, 10:38 AM »
Beagle,

Nice work!  I like the aesthetic of the forged blade.  The plane body, while shaped differently from most, looks very comfortable.
Chris Wong, http://FlairWoodworks.com

The thoughts and ideas expressed here are my own and do not necessarily represent those of http://UltimateTools.ca.  But Dan does say "hello".

Offline backwoodsbeagle

  • Posts: 12
Re: Re: Completely handmade plane.
« Reply #2 on: March 15, 2013, 10:44 AM »
Thanks! I put the blade a little too far forward so there's not much room for a comfortable two hand grip that doesn't partially block the opening on the top. 
I'll make sure to correct that on my next batch.