Author Topic: Ohishi stones?  (Read 1182 times)

0 Members and 1 Guest are viewing this topic.

Offline coug

  • Posts: 52
Ohishi stones?
« on: August 18, 2017, 11:38 AM »
I have been reading the many opinions across the web on sharpening stones.  Seems like some such as Shapton Pro's and Sigma's are hard to get in all grits.  Wondering if anyone on FOG has opinions on Ohishi?  I have seen positive references about them, but wonder what others think>

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline derekcohen

  • Posts: 145
    • In The Woodshop
Re: Ohishi stones?
« Reply #1 on: August 19, 2017, 09:35 PM »
I have not used the Ohishi, but must ask why you believe it important to have more grits than available from, say, Shapton?

For most waterstones, one needs three grits - coarse (around 1000), medium (around 5-6000), and fine (8-13000).

One can even jump grits, such as I start with a medium stone when the blade is freshly hollow ground. Or, sometimes I just re-fresh the edge on green compound (rubbed on hardwood, not leather).

Regards from Perth

Derek

Offline curiousdork

  • Posts: 46
  • I code and woodwork.
Re: Ohishi stones?
« Reply #2 on: August 20, 2017, 12:38 AM »
I don't have any experience the Ohishi stones, I found they're a bit difficult to find in the US. However, Lee Valley carries the Sigma Power Select II on their site.  The grit spreads are pretty good (1000, 3000, 10000, and 13000) and they're decently priced IMO.  If you're okay using Sigma's, I'd suggest that.

Offline coug

  • Posts: 52
Re: Ohishi stones?
« Reply #3 on: August 20, 2017, 09:39 AM »
Thanks, what I meant was that many of the grits seem to be out of stock.  I looked at the Sigma's at Lee Valley but they are out of the 3000, and going from 1000 to 10000 seems like a big jump.  Same with Shapton's, which are my first choice.  Having a hard time finding anything between 1000 and 10000.  I first looked for the Shapton Pro's, then the Sigma's.  Could not find much on the Ohishi's.

I have not used the Ohishi, but must ask why you believe it important to have more grits than available from, say, Shapton?