Author Topic: SWAN NECK CHISELS  (Read 1770 times)

0 Members and 1 Guest are viewing this topic.

Offline jmarkflesher

  • Posts: 248
  • Scoot
SWAN NECK CHISELS
« on: December 06, 2014, 07:43 PM »
http://ecx.images-amazon.com/images/I/31YBJH9ZWHL.jpg  Just asking before I order. I need to clean out the bottom of several mortise slots. I plan to order a 6mm (1/4") Swan Neck Chisel by Two Cherries for $68 delivered. Is there a better brand? Do the Japanese make the same type? Anyone have experience using one? Thanks ahead, MARK
« Last Edit: December 06, 2014, 07:54 PM by jmarkflesher »
DEC 21st, 2012 TIC TIC TIC   WAS A DUD

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline RL

  • Posts: 3039
Re: SWAN NECK CHISELS
« Reply #1 on: December 06, 2014, 10:26 PM »
I tried one once and I didn't see the point of them. When you lever them against the rear wall of the mortise (they are levered in use, not struck with a hammer), I had to be really mindful not to crush the wall and ruin the look of the mortise hole. I just went back to using a regular bench chisel.

And because the back is convex, it makes me think they must be quite hard to sharpen.

(But Lee Valley sell a Henry Taylor swan neck chisel for $34 and their gouges are quite good.)