Author Topic: MFT top from Full sheet from Phenolic film face plywood  (Read 2929 times)

0 Members and 1 Guest are viewing this topic.

Offline grayedout

  • Posts: 39
MFT top from Full sheet from Phenolic film face plywood
« on: September 06, 2017, 10:36 AM »
HI All , I am working on an idea for a MFT table using a full sheet of Ply.  not sure if this has been done could find any info ..  I am right in thinking the MFT has 20mm holes 96mm apart and 60mm in from edge ?

Will upload picture and Youtube of the build when I get this going


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Redart

  • Posts: 12
Re: MFT top from Full sheet from Phenolic film face plywood
« Reply #1 on: September 16, 2017, 11:30 PM »
Hi Andy, cant't wait to see the pictures of the build,
 the 96mm spacing isn't necessary as long as the 20mm holes are square , but most important in an assemby table top is the perfect flatness. maybe a torsion box..
Festool: CTL midi. RO 150 FEQ
Mafell: MT 55 CC, DD40 G, LO 50 E.
Nilfisk Alto attix 30 ... Makita, Bosch ,Fein and Lamello tools.