Author Topic: Post and rail job  (Read 985 times)

0 Members and 1 Guest are viewing this topic.

Offline pettyconstruction

  • Posts: 326
Post and rail job
« on: January 26, 2017, 10:07 PM »
New job
Remove rot on bottom of post and put railing back up.
The posts at the deck had a bit of rot, so we cut as little off, while removing all of it.
As it turned out, the post were made of 2xs that were glued and then turned on a lathe. The ending dimensions were 4 1/4" x 4 1/4",so just using a 6x6 was not going to work.
We used a 6x6 and cut it down to fit, then sanded it flush. ( in the u s a , lumber is smaller than the number it says i.e. 2x4 is a 1 1/2 x 3 1/2" )
Used :
Baby domino
Ro 125
Kapex
Titebond 3
Csx .
Charlie


Sent from my iPhone using Tapatalk Pro
« Last Edit: January 26, 2017, 10:13 PM by pettyconstruction »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline batau

  • Posts: 2
Re: Post and rail job
« Reply #1 on: Today at 08:46 AM »
nice job!