Author Topic: Recessed outside corner shelf unit  (Read 1738 times)

0 Members and 1 Guest are viewing this topic.

Offline Twoodman66

  • Posts: 95
Recessed outside corner shelf unit
« on: March 20, 2018, 05:04 AM »
I've been asked to build a two units like the ones pictured. The plan is to use 3/4 ply with 1.5 face frame with a rabbit for the ply leaving 3/16 edge,with 1/2 ply backing.  First I can cut each shelf out of a 24x24  piece making each one whole(much more material used) or domino 12"rips mitered.
Second I'm concerned about sagging. We would prefer no support on the outside.
Looking for suggestions here

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Mario Turcot

  • Posts: 540
Re: Recessed outside corner shelf unit
« Reply #1 on: March 20, 2018, 07:24 AM »
I like the concept  [cool]

To prevent sagging I would use the floating shelf technique in the middle and near the outside corner, with 1" dowels. Your shelves would need to be thicker tho  [eek]

Mario
Mario