Author Topic: [Project 19] Finishing Cabinet Pull Out Thing  (Read 534 times)

0 Members and 1 Guest are viewing this topic.

Offline mattbyington

  • Posts: 204
[Project 19] Finishing Cabinet Pull Out Thing
« on: February 12, 2019, 12:38 AM »
I have a sliver of about 5" between some storage racks and my tool box.

I decided to make a really skinny pull-out multi-tier thingy-ma-bober to store my Deft lacquer spray, other bottles of stuff, et cetera.

Basically anything that is really skinny ;)

Using 4 drawer slides - 2 on top and 2 on bottom... we'll see how it goes.

Almost done.

Matt


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mattbyington

  • Posts: 204
Re: [Project 19] Finishing Cabinet Pull Out Thing
« Reply #1 on: February 12, 2019, 12:39 AM »

Offline mattbyington

  • Posts: 204
Re: [Project 19] Finishing Cabinet Pull Out Thing
« Reply #2 on: February 12, 2019, 12:40 AM »

Offline tjbnwi

  • Posts: 5874
  • Cedar Tucky Indiana
Re: [Project 19] Finishing Cabinet Pull Out Thing
« Reply #3 on: February 12, 2019, 12:46 AM »
The lower set of slide should be vertical so the bearings carry the load. You only need one on top to guide.

Tom