Author Topic: [Project 8] Walnut and Cherry Necklace holder for wife's friend  (Read 1481 times)

0 Members and 1 Guest are viewing this topic.

Offline mattbyington

  • Posts: 146
[Project 8] Walnut and Cherry Necklace holder for wife's friend

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mattbyington

  • Posts: 146
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #1 on: June 23, 2018, 09:30 PM »

Offline mattbyington

  • Posts: 146
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #2 on: June 23, 2018, 09:31 PM »

Offline mattbyington

  • Posts: 146
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #3 on: June 23, 2018, 09:31 PM »

Offline duc996

  • Posts: 159
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #4 on: June 23, 2018, 09:53 PM »
 You are a building machine! Nice, did you build the little planters on the table too?

Offline Cheese

  • Posts: 5063
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #5 on: June 23, 2018, 10:02 PM »
Very nice Matt...I really like how you tried to match the cherry 🍒 grain to the walnut grain, it takes a second look to realize that this is actually a different species of wood. Clever...
What type of finish did you top it off with?

Offline mattbyington

  • Posts: 146
Re: [Project 8] Walnut and Cherry Necklace holder for wife's friend
« Reply #6 on: June 25, 2018, 03:59 PM »
Thanks so much @duc996 and @Cheese ! Really appreciate it!

I used Deft semi-gloss spray lacquer, 3 coats. It turned out "OK"...I probably should have sanded it a bit more.

I tried with the Cherry yeah! Didn't turn out exactly perfect but at least it's going in the same direction haha.

Matt