Author Topic: Cornice for kitchen  (Read 1372 times)

0 Members and 1 Guest are viewing this topic.

Offline Rob-GB

  • Posts: 1078
Cornice for kitchen
« on: March 24, 2017, 04:02 PM »
I have had to make some changes to a clients kitchen and needed some new cornice for the cabinets. The cost of getting cutters made for a spindle moulder was prohibitive for just a 3.6 meter run so I took a different route. The only cutter I had to buy was the core box cutter. Had a go at videoing this one using my Ipad so here goes...



Rob.
Problem? No such thing! Only a solution waiting to be found:- RJ

"A $2 guppy swims......" Deke

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline rst

  • Posts: 1898
Re: Cornice for kitchen
« Reply #1 on: March 24, 2017, 04:17 PM »
Great work   [smile]

Offline Billedis

  • Posts: 608
Re: Cornice for kitchen
« Reply #2 on: March 24, 2017, 04:28 PM »
Very nice video.  Thank you for sharing.  Bill

Offline awil66

  • Posts: 142
Re: Cornice for kitchen
« Reply #3 on: March 24, 2017, 07:29 PM »
Your a baaaaad man Rob-GB. Very nice.

Offline waho6o9

  • Posts: 1345
    • Garage Door Handyman.com
Re: Cornice for kitchen
« Reply #4 on: March 24, 2017, 11:30 PM »
Impressive

Offline Rob-GB

  • Posts: 1078
Re: Cornice for kitchen
« Reply #5 on: March 25, 2017, 09:09 AM »
I fitted the cornice this morning, well I installed the cabinet over the fridge ( that I made from the units I had to take out cut down the old door and face frame to make this one) the light pelmet and plinth and varnished the raw pine.



Thanks for looking in and commenting guys, appreciated.

Rob
« Last Edit: June 06, 2017, 10:21 AM by Rob-GB »
Problem? No such thing! Only a solution waiting to be found:- RJ

"A $2 guppy swims......" Deke