Author Topic: Custom sized end tables  (Read 409 times)

0 Members and 1 Guest are viewing this topic.

Offline bobberner

  • Festool Dealer
  • *
  • Posts: 43
Custom sized end tables
« on: June 10, 2017, 12:45 PM »
I almost am reluctant to post this after seeing Derek's Sofa Table post but here it is. A friend of my wife's asked if I would build her a table similar to the Cherry Enfield table in my living room. She want two tables made to the same measurements as her existing tables. She decided on Maple rather than Cherry. So I lucked out in my wood shopping and found a piece of 6/4 (for the legs) which seemed like it had a little bit of spalting and some fairly wide wormy/curly maple in 4/4 from another guy. Unfortunately the 4/4 wasn't quite wide enough to glue up for the width so I needed to add a stretcher piece. Fortunately, I got sequential boards form the tree so the tops are somewhat book matched. When I dry assembled the tables I wasn't thrilled with the overall look. The spalting looked too extreme compared to the tops. But the customer loved it so I was saved.

After putting the finish on, one coat BLO and then a catalyzed lacquer, I was a little more pleased with how they turned out. Here is a question for you furniture makers in the FOG, why aren't drawers usually the full depth of the table? It seems I see a lot of drawers that are only about half the possible length?

I used the Domino 500 for the mortices on the aprons and legs, and also to make the top glue up a little easier. The last photo is my Cherry table that she liked so much.
As addictive as crack but more expensive.

Oohhhhhhhhhh, Festool.........

MFT/3, TS 75, RO 150, OF 1400, CT Midi.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tony_sheehan

  • Posts: 96
Re: Custom sized end tables
« Reply #1 on: June 10, 2017, 12:50 PM »
Very nice indeed bobberner