Several months ago, I was given a drill press. It sat on the floor until this weekend, when I had a chance to build a cabinet/cart to put it on. It also gave me a a place to store Systainers.
Used my 1400 router, domino 500 and new TS55 for the construction. It is made out of a piece of sheeting (I didn't want to spend $55 on a sheet of good plywood for this).
I made a small miscalculation. I originally was going to put the dado for the middle shelf at 630mm from the bottom. But I started to overthink things and I decided on 635 instead. The problem this created is that the two sys-2's stacked up are very snug against the top. If I would have stuck with my 630mm it would have been perfect.