Author Topic: First Project - DIY MFT  (Read 605 times)

0 Members and 1 Guest are viewing this topic.

Offline rdr

  • Posts: 19
First Project - DIY MFT
« on: April 13, 2017, 04:18 PM »
My tools turned up this week and for my first job I thought I would keep it simple and  build a basic MFT/fabrication table.

I may well get an MFT3 at some stage but they looked a bit small and I thought I would have a go and see how I get on with a DIY version to start with. I normally play with metal so went with an MFT top on a metal frame for now with the intention of building SYSports and storage underneath it. Heres a few pics of the build;

Phase one - The Top

8x4 sheet of 18mm MDF cut down to 1500x800 using the TS55 and various tracks, I had trouble with the tracks getting them to lay flat together, the saw wouldn't run smooth between the two. I will post further details on my issue in another thread. I then lined up the CNC Pro JIG ready to cut some holes with the OF1010:

261583-0



All went quite smoothly double checking alignment when moving the jig along being key:
261585-1

Completed the hole cutting in about an hour, dust extraction was amazing.

261587-2

Phase 2 - The Frame
I  used 30x30x2.5mm Angle making the top frame a perfect and snug fit for the 18mm slab. I decided not to physically attach the MDF to the frame instead making it tightly fit into the corners of the frame where the angle sits 5mm higher to grip it. I will see how this works over time.
261589-3
261591-4

Legs on and then its all welded up and castors fitted.
261593-5
Finished with a coat of Festool grey paint:

261595-6


Initial checks indicate the holes are square and work with the parf dogs I have so I will see how it goes. I may well look at adding a fence of some sort to it next. Overall pretty pleased with it for a couple of hours work and less than £50 in materials it will do me for starters  [smile]

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline rvieceli

  • Posts: 683
Re: First Project - DIY MFT
« Reply #1 on: April 13, 2017, 05:14 PM »
Excellent work! Nice to see the coped corners on the angle iron. [big grin]

Ron