Unfortunately  I don't have work in progress photos, since I did this about a month ago, but I kind of doubt I'd ever have the time to document the building process anyway. This box is a design from Basic Box Making by Doug Stowe, though I wouldn't quite call this one basic. Purpleheart and Maple. I used a TS55 for ripping all the pieces the then cut them to size with a Nobex miter saw. Sanding was done with an RO125 EQ. There was also a lot of time on the router table. Finish is shellac, ceramithane, then carnauba wax on the outside, just renaissance wax on the inside.

The dividers are removable, the were done with half laps. Brass hinges are from Horton Brasses. Total dimensions are 6" x 8" x 6" closed and quite a bit bigger open. And if anyone's wondering, the piece of purpleheart attached to the back is only attached to the uppermost "drawer" and keep the whole thing from toppling over when it's fully open.

Front



Side



Back



Top



Open Top



Fully Opened




Pedro

....and great photos!

Router table with a jig to hold the box at 45 degrees.

Pedro

Neil,

Purpleheart, not walnut. Walnut would have been so much easier to work with, but then again it really doesn't look much like purpleheart.  Purpleheart likes to tear out. A lot!

There are no washers. The brass screws are lubricated, but that isn't essential. The holes in the braces are slightly oversized so that they move freely as long as the screws aren't overly tightened.

As for photography, I just don't use a flash, and preferably photograph in a room with white walls to reflect light. You do need a tripod though as this results in long exposures. I took the photos on my kitchen table; I got rid of the background in photoshop.

Pedro