Author Topic: Had some spare time  (Read 1055 times)

0 Members and 1 Guest are viewing this topic.

Offline JCLP

  • Posts: 734
Had some spare time
« on: July 14, 2017, 01:10 PM »
Well, instead of watching TV, I decided to see if I could make a Walnut edge grain cutting board. Turned out to be fairly simple and quick to make.
Thought I would share.

Cheers,
JC

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline copcarcollector

  • Posts: 1361
Re: Had some spare time
« Reply #1 on: July 14, 2017, 03:03 PM »
---  [scared] But, TV !!!

Looks great!

Online Cheese

  • Posts: 3585
Re: Had some spare time
« Reply #2 on: July 14, 2017, 04:07 PM »
Nice job... [thumbs up]. Just curious what the recess in the bottom is for?

Offline rvieceli

  • Posts: 724
Re: Had some spare time
« Reply #3 on: July 14, 2017, 04:23 PM »
I bet there's another one on the other end.  [wink]

They make a handle/finger grip. [big grin]

Offline JCLP

  • Posts: 734
Re: Had some spare time
« Reply #4 on: July 14, 2017, 04:43 PM »
Nice job... [thumbs up]. Just curious what the recess in the bottom is for?
The cutting board sits flush on the counter. I chose not to put feet on it and instead create a recess on both sides for your fingers to grip. As the board weighs close to 7 lbs, having your fingers grip something makes it easier to lift.

Cheers,
JC