Author Topic: Hall Table  (Read 2845 times)

0 Members and 1 Guest are viewing this topic.

Offline Rob McGilp

  • Posts: 430
  • Curmudgeon
    • Damn Fine Furniture
Hall Table
« on: August 27, 2007, 01:55 PM »
Hi all,

This is a hall table to match the red Gum and Huon Pine coffee table. Same routine. TS75, Band Saw to taper the legs, Domino joints and RO150 sanding. One new thing though, used the Kapex for the cross cutting and mitres. I hope the mitres improve though, you can still see the join. ::)

Regards,

Rob

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Bob Childress

  • Posts: 121
  • South Carolina, USA
Re: Hall Table
« Reply #1 on: August 27, 2007, 03:35 PM »
Nice work Rob.    ;D ;D  Decided to taper the legs all four sides? Looks good.

Ooops. Camera trick (or old eyes). Two sides tapered.  ;)
« Last Edit: August 28, 2007, 07:29 AM by Bob Childress »
TS-55, RO-150, ETS-150/3, DX-93, LS-130, CT-22, OF-1000, DF-500Q, C-12

Offline Terry Fogarty

  • Posts: 393
Re: Hall Table
« Reply #2 on: August 27, 2007, 06:37 PM »
Looks fantastic Rob. Great miters ;D
.

Offline Eli

  • Posts: 2501
  • A Yankee in Kangaroo Court
    • Metafizix
Re: Hall Table
« Reply #3 on: August 28, 2007, 06:32 AM »
Nice job Rob.
Do nothing, stay ahead.