Author Topic: Holder for Incra Magnalock rings  (Read 1121 times)

0 Members and 1 Guest are viewing this topic.

Offline promark747

  • Posts: 458
Holder for Incra Magnalock rings
« on: April 17, 2017, 12:46 PM »
I was looking for a way to store the rings for easy identification and retrieval, so I made a quick holder using my TS55 (locked on the rail so it would plunge in the same location) and my Incra LS to evenly space the slots.  Quick and simple.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Mismarked

  • Posts: 137
Re: Holder for Incra Magnalock rings
« Reply #1 on: April 17, 2017, 04:59 PM »
Great idea, and perfect timing.  I was just trying to figure out how to do that for my Jessem rings.

Offline HarveyWildes

  • Posts: 716
Re: Holder for Incra Magnalock rings
« Reply #2 on: April 17, 2017, 09:33 PM »
Yep - I did the nearly the same things.  Not twins, but could be siblings.