Author Topic: My new router table build  (Read 1018 times)

0 Members and 1 Guest are viewing this topic.

Offline Chris450

  • Posts: 6
My new router table build
« on: March 06, 2017, 06:17 PM »
working on this router table for a couple of days, 2200 plate to act as quick release, added cs50 sliding carriage, still a few bits to finish, but happy with the results.

Sent from my SM-G935F using Tapatalk


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Sparktrician

  • Posts: 3274
Re: My new router table build
« Reply #1 on: March 06, 2017, 06:22 PM »
Pictures, or it didn't happen! 

 [poke]
- Willy -

 "Remember, a chip on the shoulder is a sure sign of wood higher up." - Brigham Young

Offline estley

  • Posts: 79
Re: My new router table build
« Reply #2 on: March 06, 2017, 06:23 PM »
just out curiosity, what is the green sheet material you used? i've seen it used by UK people both on the FOG and on youtube. Is it some form of mdf?


Sent from my iPad using Tapatalk HD

Offline Chris450

  • Posts: 6
Re: My new router table build
« Reply #3 on: March 06, 2017, 06:25 PM »
Mr mdf

Sent from my SM-G935F using Tapatalk


Offline Chris450

  • Posts: 6
Re: My new router table build
« Reply #4 on: March 06, 2017, 06:26 PM »
Pictures, or it didn't happen! 

 [poke]
Are the ones in the post not enough

Sent from my SM-G935F using Tapatalk