Author Topic: Ottoman frame  (Read 944 times)

0 Members and 1 Guest are viewing this topic.

Offline marky harvey

  • Posts: 15
Ottoman frame
« on: November 26, 2015, 03:15 PM »
Hi

I'm looking for some advice about what type of joints to use for a frame for a simple ottoman/footstool. I've attached a picture of a really rough prototype which has mitred corners with dominos. Is a mitred joint a good idea or would a rabbet or something else be better?  If anyone has a design for the frame that would be great.

Thanks

Mark
RO 150, Kapex KS 120, BS85, T18, MFT, TS55R

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline JD2720

  • Posts: 963
Re: Ottoman frame
« Reply #1 on: November 26, 2015, 04:31 PM »
That looks fine to me.  Good work.