Author Topic: Router table finished  (Read 888 times)

0 Members and 1 Guest are viewing this topic.

Offline Chris450

  • Posts: 6
Router table finished
« on: April 14, 2017, 04:08 PM »
Mash up of festool, ukj and incra, turned out better than expected and it's super accurate

Sent from my SM-G935F using Tapatalk


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline ddb

  • Posts: 16
Re: Router table finished
« Reply #1 on: April 15, 2017, 02:23 AM »
That's looking really great!
What router do you put under there?
Did you incorporate a lift as well?


Sent from my iPhone using Tapatalk

Offline VW MICK

  • Posts: 776
Re: Router table finished
« Reply #2 on: April 15, 2017, 02:43 AM »
Looks good

I'm working on mine at the moment. Is that a Festool sliding table?

Mick

Offline Chris450

  • Posts: 6
Re: Router table finished
« Reply #3 on: April 15, 2017, 06:22 AM »
That's looking really great!
What router do you put under there?
Did you incorporate a lift as well?


Sent from my iPhone using Tapatalk
I've got the of2200 mounted on one of the accessory plates so it's quick release. Not sorted a lift as such yet, using a bottle jack at the moment seems to work pretty well.

Sent from my SM-G935F using Tapatalk


Offline Chris450

  • Posts: 6
Re: Router table finished
« Reply #4 on: April 15, 2017, 06:23 AM »
Looks good

I'm working on mine at the moment. Is that a Festool sliding table?

Mick
Yes mate, it's off my cs50.

Sent from my SM-G935F using Tapatalk


Offline charley1968

  • Posts: 457
Re: Router table finished
« Reply #5 on: April 15, 2017, 02:22 PM »
Looking good!
Just for today..