Author Topic: Sliding Tenon Breadboard  (Read 267 times)

0 Members and 1 Guest are viewing this topic.

Offline Birdhunter

  • Posts: 1924
  • Woodworker, Sportsman, Retired
Sliding Tenon Breadboard
« on: September 11, 2017, 03:14 PM »
After 5 so so tries, I found a neat way to attach a breadboard end to a 33" wide oak bed headboard.

I made a wide tenon 8mm thick and cut a 10mm slot in the end.



I made a jig for this cut that I am not showing.

Next, I cut an 8mm wide mortise in the end of the headboard and then cut a 10mm slot intersecting the 8mm mortise.





Birdhunter

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.