Author Topic: Stackstone fireplace with walnut mantle  (Read 964 times)

0 Members and 1 Guest are viewing this topic.

Offline Brian Livingstone

  • Posts: 118
Stackstone fireplace with walnut mantle
« on: June 03, 2017, 11:30 AM »
 Hi,

I recently completed this feature wall.  Stackstone installed with Omni Grip adhesive.

I cut the mantle with my Kapex.

I used all my sanders.  I used the LS130 to round over the edges.

I used my TS75 to cut a rebate in the mantle, to rest on the stone.

The mantle is ABW.  No tariff paid on the wood even though it is American.

Arm r seal was the finish.

I hope you like it.

Brian
Kapex, TS75, MFT, OF1010, OF1400, DTS400 REQ, Parallel guide rails, 1080, 1400, 3000 guide rail, Domino 500, CT36, ETS 150/3, RS2E, Crown stops, 6 drawer Sortainer, Carvex, Syslite II, Festool safety glasses must start to wear.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Billedis

  • Posts: 574
Re: Stackstone fireplace with walnut mantle
« Reply #1 on: June 03, 2017, 12:29 PM »
Very nice, I like the sapwood in the walnut mantle.  Thank you for sharing.  Bill

Offline Mismarked

  • Posts: 119
Re: Stackstone fireplace with walnut mantle
« Reply #2 on: June 05, 2017, 12:07 PM »
Very nice.  I am having trouble understanding what you meant by the rebate that rests on the stone.  Did you insert some kind of metal bar into a groove that you cut with the TS75 and use it to attach to the stone?

Offline jpmeunier

  • Posts: 11
Re: Stackstone fireplace with walnut mantle
« Reply #3 on: June 05, 2017, 12:20 PM »
Very nice.  I am having trouble understanding what you meant by the rebate that rests on the stone.  Did you insert some kind of metal bar into a groove that you cut with the TS75 and use it to attach to the stone?

I'm sure he meant rabbet.