Author Topic: Staircase  (Read 972 times)

0 Members and 1 Guest are viewing this topic.

Offline Chuck Wilson

  • Posts: 139
Staircase
« on: July 12, 2017, 09:54 PM »
Wife and daughter are going out of town next week so I decided to hire someone to sand our wood floors on the first floor of the house and I am refinishing my staircase.  So far, I have removed the trim and spindles and have numbered all of the pieces so they go back in the correct spots.
265573-0265575-1
I wanted to remove the handrail as it will be much easier to refinish but have run into a situation.  There are connectors (see below) and a threaded rod connecting a butt joint holding together sections of rail.
265577-2265579-3265581-4
Anyone familiar with how this works and how to tighten and loosen? . Also, any recommendations on a really hard poly?  I've heard General Finishes has a good product but have no experience with it.

Thanks in advance,
Chuck

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Naildrivingman

  • Posts: 341
Re: Staircase
« Reply #1 on: July 14, 2017, 05:47 AM »
You have a draw bolt in that picture.  It is called that because it "draws" two surfaces together.  Generally it is used in handrail, countertop and other situations where one desires a super tight fit between two square edges.  The draw bolts act like a permanent pipe/bar clamp.

Now the bad news.  The joint is probably glued and separating the two may be unlikely.  If you have the space, I would leave it as one assembly.  If you need to separate the two, you may have to clean up the mating surfaces on a miter saw, but I can't full throatedly recommend that.  In doing so, you may not get the cuts just right and leave for yourself a miserable reinstallation process.

Hope this helped.  Good luck.

Chris
Dance with who brung ya...

Online Cheese

  • Posts: 3597
Re: Staircase
« Reply #2 on: July 14, 2017, 11:23 AM »

Also, any recommendations on a really hard poly?  I've heard General Finishes has a good product but have no experience with it.


I really like Bona Traffic, it's really tough. They also make a Traffic AS (anti-slip) that I'd highly recommend for the treads.

The photos below show how the nails of a 90# Golden will actually dent hard maple, yet the Traffic finish is still left intact.