Author Topic: The Sloth Table  (Read 3646 times)

0 Members and 1 Guest are viewing this topic.

Offline Rob McGilp

  • Posts: 430
  • Curmudgeon
    • Damn Fine Furniture
The Sloth Table
« on: April 24, 2007, 12:18 AM »
Hi everyone,
A while back I decided that I needed a table to sit next to my sofa that could be used as a reading, beverage, nosh repository that could be moved with minimum effort. In essence, a "Sloth Table"
This table is made using only Dominoes, even to the extent that the inserts are dominoed to the rails, using one cut width in the rail and 2 cut widths in the insert to allow for movement. The whole deal took 6 hours from cut up to buffing and adding the wheels (notably absent in these pics). The table was finished using an RO150 starting at 80g then through to 400g, when Scandinavian oil was added. It was then friction sealed with the RO through to 1500g, waxed then buffed. The timbers are WA Jarrah for the frame and New Guinea Rosewood for the top and shelf.

Regards,

Albert. (Don't know any Orsons)

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Dan Clark

  • Posts: 542
    • talkFestool
Re: The Sloth Table
« Reply #1 on: April 24, 2007, 09:11 AM »
Albert,

Very nice!   Especially the project time.   ;D

Regards,

Dan.

Offline Christian A.

  • Posts: 77
  • Austria
Re: The Sloth Table
« Reply #2 on: April 24, 2007, 03:40 PM »
Nice and - apparently rock-solid - table. Wood and finish look beautiful. Thanks for the pics.

Regards,

Christian
This message was written by Christian Aufreiter, student and hobby woodworker living in Austria.
NO AFFILIATION with Festool and Christian O., who is another member of this forum.