Author Topic: Walnut and Hard Maple Moxon Vise  (Read 695 times)

0 Members and 1 Guest are viewing this topic.

Offline Trevin

  • Posts: 63
Walnut and Hard Maple Moxon Vise
« on: September 02, 2017, 02:37 PM »
Hi Foggers,
I just finished up a Moxon vise build for my shop.  The plans for this vise came from Dustin Penner (you tube).  I really liked his mix of woods in making his vise so I build mine with walnut and hard maple.  The hardware came from Benchcrafted and I must recommend their hardware.  Everything is very smooth and I love the fit and finish of the hardware.  I finished this vise by sanding with granat to 220 then applied Waterlox.  This was my first time using Waterlox and I really do like it.  It applies easily and I did not have any issues with runs at all.  I did lightly sand with 500 platin between coats by hand.  Take a look.

Now to go cut some dovetails for my next project.

Thanks,
Trevin
Festool: MFT3 (x2), OF1010, OF1400, LR32, Domino DF500, Domino XL DF700, Kapex KS120, TS-75, Carvex 420, CXS, C-18, Vecturo OS 400, DTS 400, Pro 5, Rotex 125, VAC-PMP, VAC-SYS-1, VAC-SYS-2, CT-26 (x2), CT-SYS, SYS Light DUO, SYS-ROCK
Other: Minmax FS41, Sawstop PCS (3HP, 52"), Laguna BX14, Jet 17" Drill Press, Rikon 70-220VSR Lathe, Incra LS Router Station, Laguna P/Flux 3 Dust Collector

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline HarveyWildes

  • Posts: 529
Re: Walnut and Hard Maple Moxon Vise
« Reply #1 on: September 02, 2017, 02:53 PM »
Nice job.  Walnut and maple were made for each other.

Offline mrFinpgh

  • Posts: 219
Re: Walnut and Hard Maple Moxon Vise
« Reply #2 on: September 02, 2017, 03:42 PM »
Very nice.  I wonder if the walnut will make the vice 'grip' the wood any better, due to it's slight softness? 

I have the same kit, and I'm sure the crubber will be ample grip, but it would be interesting to know if there is a meaningful difference in using a softer wood vs a harder wood for the jaws.