Author Topic: Pinner recomendation  (Read 4963 times)

0 Members and 1 Guest are viewing this topic.

Offline gpl916

  • Posts: 27
Re: Pinner recomendation
« Reply #30 on: October 21, 2018, 04:15 PM »
Here is a partially done picture. I had to clean up as my wife was throwing a baby shower.

I just laid in and finished the Herringbone floor and installed the doors. There was no entrance to that room here. I still have to add the horizontal pieces that will make up the approximate 2'x2' squares.

This trim was really my first use of my Felder combination shaper/saw/JP. I need to make some back band, that stuff was expensive!

The Pinner along with the glue actually worked well.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.