Author Topic: Pinner recomendation  (Read 5248 times)

0 Members and 1 Guest are viewing this topic.

Offline gpl916

  • Posts: 27
Re: Pinner recomendation
« Reply #30 on: October 21, 2018, 04:15 PM »
Here is a partially done picture. I had to clean up as my wife was throwing a baby shower.

I just laid in and finished the Herringbone floor and installed the doors. There was no entrance to that room here. I still have to add the horizontal pieces that will make up the approximate 2'x2' squares.

This trim was really my first use of my Felder combination shaper/saw/JP. I need to make some back band, that stuff was expensive!

The Pinner along with the glue actually worked well.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Cincinnati

  • Posts: 49
Re: Pinner recomendation
« Reply #31 on: Yesterday at 03:03 AM »
I’ve had my eyes on both Grex and Cadex for a while now.  Are there any Cadex users out there in FOG land. I don’t see too many reviews about that brand.

I bought a Cadex 23 ga pinned about 8 years ago, because it Took highest honors in a review by Fine Homebuilding.  I’ve never regretted that purchase. I used it last month to hold backs on cabinets until glue dried. I used it to install baseboard, shoe mounding, and door trim. I’ve also used it in jig building to hold wood until glue dries.  I’ve only had 2 jams out of maybe 1000 nails.

At IWF Atlanta I tried out the Grex Cordless 23ga pinner. It is one sweet gun.im considering selling my Cadex.

Offline rst

  • Posts: 2007
Re: Pinner recomendation
« Reply #32 on: Yesterday at 09:35 AM »
I've used multiple makes of air tools over the years.  Senco was the industrial standard and I had and still have a couple.  My go to's now are my Grex's, 18 ga, 23 ga pinners, 23 ga stapler, 7/16 stapler.