Author Topic: TSO 20mm Workholding Accessories Review  (Read 14529 times)

0 Members and 1 Guest are viewing this topic.

Offline Richard/RMW

  • Posts: 1865
Re: TSO 20mm Workholding Accessories Review
« Reply #30 on: January 25, 2018, 07:42 PM »
I believe Hans has hit on a key point in the 20mm-fit debate, i.e. that while really very consistent the holes in a stock MFT were not intended to be precise to thousandths of an inch as they were only meant for clamping.  Our ability to use dogs and precisely line up stock & guide rails is just a happy side effect from CNC manufacturing.

As always, I could be all wet.

As of 10/17 I am out of the Dog business and pursuing other distractions. Thanks for a fun ride!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tomdog4

  • Posts: 3
Re: TSO 20mm Workholding Accessories Review
« Reply #31 on: February 06, 2018, 04:05 PM »
Hans, can you comment on the fit of either of the dogs in a Fastcap Paulk workbench? The holes are cut by CNC so I'm guessing the "close fit" would work, but would appreciate first hand input if anyone knows!