Author Topic: 4n1 drill driver combo  (Read 1781 times)

0 Members and 1 Guest are viewing this topic.

Offline UncleJoe

  • Posts: 139
4n1 drill driver combo
« on: May 28, 2017, 08:56 AM »
I could not find a consistent name for this item. I have the Lowes set shown below and it works fairly well


It allows me to drill a pilot hole and countersink, then quickly switch and drive the screw home. My only issue is that there is very limited depth control on the drill side. If you set the drill so it only drills a shallow hole, like for a 1 inch screw, the end of the drill sticks too far out the back side of the countersink and you can't put it back in the holder.

It seems hard to find these. I have seen the Dewalt and Makita and the Montana. I can't tell if any allow you to shorted the drill bit depth of cut.

Anyone have good experience with something like this.

As always, thanks for your input
I am not young enough to know everything!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Bob D.

  • Posts: 807
Re: 4n1 drill driver combo
« Reply #1 on: May 28, 2017, 01:02 PM »
Craftsman offered these years ago, don't know if they still do. I think Ryobi has one similar.
Don't know if any of them are interchangeable though at first glance they appear the same.

-----
It's a table saw, do you know where your fingers are?

Offline rst

  • Posts: 1973
Re: 4n1 drill driver combo
« Reply #2 on: May 29, 2017, 10:05 AM »
I've had a Makita version for 10-15 years.  I hard ever use mine.  Not because it is not useful but because I usually just use multiple drivers.

Offline RobBob

  • Posts: 1314
Re: 4n1 drill driver combo
« Reply #3 on: May 29, 2017, 10:36 AM »
FWIW, I have the Craftsman version from Sears, but I too, prefer to use two drills instead.