Author Topic: dewalt 745  (Read 876 times)

0 Members and 1 Guest are viewing this topic.

Offline anatoli

  • Posts: 7
dewalt 745
« on: December 09, 2015, 07:19 PM »
Hi.

The fence on the saw is not perpendicular to the table. About 1/32 from top to button. Cannot find any adjustments.
the manufacturer sand new one, same problem. Any advise?
Thank you

Anatoli.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 11006
  • Moderator on a Slow Day
Re: dewalt 745
« Reply #1 on: December 09, 2015, 08:25 PM »
I would suggest that you call DeWalt service and ask the question.  I have the 744 and any adjustments would have to be done with adjusting the rails up or down on that saw I believe so that might ultimately what you have to do with yours.

Peter

Offline anatoli

  • Posts: 7
Re: dewalt 745
« Reply #2 on: December 10, 2015, 12:13 PM »
thank you
Anatoli